Golden-lighting 1208-3P DNI Bedienungsanleitung PDF herunterladen

Assembly Instructions: 1208-3P DNI (Marcellis)

IMPORTANT:

• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.

• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!

• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!

PREPARING FOR INSTALLATION

Carefully remove all of the contents from the carton. See the

important notes above. Shut off the power at the circuit breaker

andcompletelyremovetheoldxturefromthewall,including

theoldmountingstrap.

Fromthepartsbagremovethemountingstrapassembly.One

endofnipple(F)shouldbeattachedtomountingstrap(A)with

washerandhexnuts(C&D)inplace.Theotherendshouldhave

canopy loop (H) attached.

Attachmountingstrap(A)tothejunctionboxusingmounting

screws(B)andascrewdriver.Tightensecurely.Unscrewcanopy

loop collar (I) from canopy loop (H). Pass canopy (G) over the

mountedcanopylooptotesttheheight.Approximatelyhalf

ofthecanopyloop’sexteriorthreadsshouldbeexposed,and

thecanopyloopcollarshouldtsnuglyontothecanopyloop.

Removecanopy(G)andadjusttheheightofnipple(F)and

canopyloop(H)untilthedesiredheightisreached.

Bymeasuring,determinethecorrectamountofchainandwire

neededforproperhangingheight.Ifnecessary,useapairof

plierstoopenandremoveanyexcesschain.Attachoneofchain

connectors(K)toeachendofchain(J).Passthexturewires

throughtoploop(H).Attachoneendofchain(J)totoploop(L)

usingchainconnector(K)andclosechainconnector(K).Attach

oneendofeachrod(O)todecorativehooks(N)onxturebody

(P). Use the free end of rod (O) to attach the rod to the hooks on

top cap (M). Use the free chain connector (K) to attach chain (J)

tocanopyloop(H).Feedthexturewiresupthroughthechain

(everythreelinksorso),pullingthewiresuntiltaut.Trimthewires

tothedesiredlengthplus8to10inches.

CONNECTING THE WIRES

Haveanassistantsupportthextureweightwhilecompleting

thewiring.Threadthexturewiresthroughcanopy(G).Attach

thexture’swirestothepowersupplywiresfromthejunction

box.Connectblacktoblack(orsmooth);whitetowhite(or

ribbed);groundtoground(greenorcopper).Twisttheendsof

thewirepairstogether,thentwistonawireconnector.Make

surealltwistsareinthesamedirection.Ifthereisnogroundwire

(greenorcopper)fromthejunctionbox,locategroundscrew(E)

onmountingstrap(B)andwrapthexturegroundwirearound

thegreengroundscrew(E).Useascrewdrivertosecureground

screw(E)ontothemountingbracket.Tuckallwiresneatlyinto

thejunctionbox.

FINISHING THE INSTALLATION

Note: Completetheremainingstepsafterthextureishung.

Tightenthedecorativehammerednials(T)ontothethreadsat

thebottomofthexturearms.

Carefullyslideglassshades(Q)oversockets(S).Candlesleeves

(R)haveretainingringsattached.Eachretainingringhastwo

smallholesineachside.Theglassshadeopeningistight.

Carefullypushthecandlesleevesdownintotheglassshades

and over the sockets. Carefully place the tips of socket tool (U)

intotheholesintheretainingring.Usesockettool(U)tothread

theretainingringsontothesocketthreads.Thiswillsecurethe

glassinplace.

Installlightbulbsinaccordancewiththexture’sspecications.

Donotexceedthemaximumrecommendedwattage.

Your installation is now complete. Turn on the power and test the

xture.

CLEANING TIPS

Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the

xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.

For Customer Service, contact

the place of purchase to arrange

for replacement parts.

BLACK

(Hot)

WHITE

(Neutral)

GREEN

(Ground)

HOUSE WIRES

SMOOTH

(Or Black)

FIXTURE WIRES

RIBBED

(Or White)

BARE COPPER

(Or Green)

Inhaltsverzeichnis

Seite 1 - FINISHING THE INSTALLATION

Assembly Instructions: 1208-3P DNI (Marcellis)IMPORTANT: • ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL. • SHUT OFF POWER SUPPLY

Kommentare zu diesen Handbüchern

Keine Kommentare

Golden-lighting 1208-3P DNI Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Golden-lighting 1208-3P DNI herunter. Golden Lighting 1208-3P DNI User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Golden-lighting 1208-3P DNI